Welcome to the new location of Alien's Wiki, sharing a single dokuwiki install with the SlackDocs Wiki.
Welcome to Eric Hameleers (Alien BOB)'s Wiki pages.
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Last revisionBoth sides next revision |
| slackware:samba [2006/03/29 19:27] – alien | slackware:samba [2018/11/02 20:16] – Small fixes to modernize the instructions. alien |
|---|
| |
| FIXME ** This article is being worked on ** FIXME | |
| --------------------------------------------------- | |
| |
| ===== File- and printersharing on the local network ===== | ===== File- and printersharing on the local network ===== |
| |
| |
| * This should be in ''/etc/samba/smb.conf'', it defines the password backend Sabma will use (I will not discuss the alternative LDAP backend here, I hope to write another article on that all of it's own): <code> | * This should be in ''/etc/samba/smb.conf'', it defines the password backend Sabma will use (I will not discuss the alternative LDAP backend here, I hope to write another article on that all of it's own): <code> |
| passdb backend = tdbsam guest | passdb backend = tdbsam:/var/lib/samba/private/passdb.tdb |
| </code> //NOTE//: when you enable //tdbsam// on an already configured and running Samba server, and run ''killall -HUP smbd'' to let it re-load the configuration files, you might have to re-add the 'smbguest' user to Samba, since the default to use is the //smbpasswd// file and not the tdbsam database.\\ So, again run: <code> | </code> //NOTE//: when you enable //tdbsam// on an already configured and running Samba server, and run ''killall -HUP smbd'' to let it re-load the configuration files, you might have to re-add the 'smbguest' user to Samba. \\ In the past, the default to use was the //smbpasswd// file but since Sa,ba 3.4 the tdbsam database became the default.\\ So, again run: <code> |
| smbpasswd -a smbguest -d | smbpasswd -a smbguest -d |
| </code> | </code> |
