Welcome to the new location of Alien's Wiki, sharing a single dokuwiki install with the SlackDocs Wiki.
Welcome to Eric Hameleers (Alien BOB)'s Wiki pages.
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision |
slackware:rt2xxx [2006/08/18 22:21] – The downloaded SlackBuild is not executable, use 'sh' alien | slackware:rt2xxx [2008/03/10 23:06] – Fix incorrect IWPRIV example. alien |
---|
sh rt2500.SlackBuild | sh rt2500.SlackBuild |
</code> THe resulting package will be created in the ''/tmp'' directory and can be installed with (for example) <code> | </code> THe resulting package will be created in the ''/tmp'' directory and can be installed with (for example) <code> |
installpkg /tmp/rt2500-1.1.0.b3_2.6.13-i486-1.tgz | installpkg /tmp/rt2500-1.1.0.b4_2.6.13-i486-1.tgz |
</code> | </code> |
| |
WLAN_MODE[5]=Managed | WLAN_MODE[5]=Managed |
WLAN_CHANNEL[5]="auto" | WLAN_CHANNEL[5]="auto" |
WLAN_IWPRIV[5]="AuthMode=WPAPSK EncrypType=TKIP WPAPSK=1234567890123456789012345678901234567890123456789012345678901234" | WLAN_IWPRIV[5]="set AuthMode=WPAPSK | set EncrypType=TKIP | set WPAPSK=1234567890123456789012345678901234567890123456789012345678901234" |
</code> | </code> |
The last line (//WLAN_IWPRIV[5]//) is the necessary configuration for WPA. The 64-character string '//12345.....901234//' I copied in there should be replaced by your Access Point's 64-character hexadecimal WPA key. | The last line (//WLAN_IWPRIV[5]//) is the necessary configuration for WPA. The 64-character string '//12345.....901234//' I copied in there should be replaced by your Access Point's 64-character hexadecimal WPA key. |
| |
| <note warning>The above notation for the **//WLAN_IWPRIV//** variable has changed starting with Slackware 12.0. The old notation for ''IWPRIV'' in before Slackware 12.0 was like this: \\ ''WLAN_IWPRIV[5]="AuthMode=WPAPSK EncrypType=TKIP WPAPSK=the64characterkey"'' \\ Starting with Slackware 12.0, you should use the new syntax <code> |
| WLAN_IWPRIV[5]="set AuthMode=WPAPSK | set EncrypType=TKIP | set WPAPSK=the64characterkey" |
| </code></note> |