Welcome to the new location of Alien's Wiki, sharing a single dokuwiki install with the SlackDocs Wiki.
Welcome to Eric Hameleers (Alien BOB)'s Wiki pages.
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revisionNext revisionBoth sides next revision |
slackware:rt2xxx [2006/03/28 22:23] – created alien | slackware:rt2xxx [2007/05/12 11:29] – Added IWPRIV example for Slackware > 11.0 alien |
---|
</code> When this command completes, you will end up with a subdirectory called "//build//" in your current directory. Build the package as follows: <code> | </code> When this command completes, you will end up with a subdirectory called "//build//" in your current directory. Build the package as follows: <code> |
cd build | cd build |
./rt2500.SlackBuild | sh rt2500.SlackBuild |
</code> THe resulting package will be created in the ''/tmp'' directory and can be installed with (for example) <code> | </code> THe resulting package will be created in the ''/tmp'' directory and can be installed with (for example) <code> |
installpkg /tmp/rt2500-1.1.0.b3_2.6.13-i486-1.tgz | installpkg /tmp/rt2500-1.1.0.b4_2.6.13-i486-1.tgz |
</code> | </code> |
| |
WLAN_MODE[5]=Managed | WLAN_MODE[5]=Managed |
WLAN_CHANNEL[5]="auto" | WLAN_CHANNEL[5]="auto" |
WLAN_IWPRIV[5]="AuthMode=WPAPSK EncrypType=TKIP WPAPSK=1234567890123456789012345678901234567890123456789012345678901234" | WLAN_IWPRIV[5]="set AuthMode=WPAPSK | set EncrypType=TKIP | set WPAPSK=1234567890123456789012345678901234567890123456789012345678901234" |
</code> | </code> |
The last line (//WLAN_IWPRIV[5]//) is the necessary configuration for WPA. The 64-character string '//12345.....901234//' I copied in there should be replaced by your Access Point's 64-character hexadecimal WPA key. | The last line (//WLAN_IWPRIV[5]//) is the necessary configuration for WPA. The 64-character string '//12345.....901234//' I copied in there should be replaced by your Access Point's 64-character hexadecimal WPA key. |
| |
| <note warning>The above notation for the **//WLAN_IWPRIV//** variable has changed after Slackware 11.0. The new notation for ''IWPRIV'' in newer releases of Slackware is like this: |
| <code> |
| WLAN_IWPRIV[5]="AuthMode=WPAPSK EncrypType=TKIP WPAPSK=1234567890123456789012345678901234567890123456789012345678901234" |
| </code></note> |