Welcome to the new location of Alien's Wiki, sharing a single dokuwiki install with the SlackDocs Wiki.
Welcome to Eric Hameleers (Alien BOB)'s Wiki pages.
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Last revisionBoth sides next revision |
| slackware:network [2017/06/25 16:25] – [Alternative network managers] Added NM alien | slackware:network [2017/06/25 16:56] – Some re-phrasing of the intro. alien |
|---|
| //This article is intended as a reference guide to network card configuration in Slackware.//\\ The network scripts themselves are well-documented (inside the scripts) but there is not much other written end-user documentation about what you put into the configuration files. The [[http://slackbook.org/html/network-configuration-tcpip.html|Network Configuration]] chapter in the //[[http://slackbook.org/html/|Slackware Linux Essentials]]// book explains in generic terms how Slackware's network configuration works, and how the use of DHCP (dynamic IP address assignment) differs from static IP's. I will try not to repeat what is written there.\\ There is another nice and freely available book on Slackware, called //[[http://slackbasics.org/html/|Slackware Linux Basics]]//. This book should be considered as required follow-up reading material once you mastered the Slackware Essentials. The [[http://slackbasics.org/html/netconfig.html|networking chapter]] is well worth reading. | //This article is intended as a reference guide to network card configuration in Slackware.//\\ The network scripts themselves are well-documented (inside the scripts) but there is not much other written end-user documentation about what you put into the configuration files. The [[http://slackbook.org/html/network-configuration-tcpip.html|Network Configuration]] chapter in the //[[http://slackbook.org/html/|Slackware Linux Essentials]]// book explains in generic terms how Slackware's network configuration works, and how the use of DHCP (dynamic IP address assignment) differs from static IP's. I will try not to repeat what is written there.\\ There is another nice and freely available book on Slackware, called //[[http://slackbasics.org/html/|Slackware Linux Basics]]//. This book should be considered as required follow-up reading material once you mastered the Slackware Essentials. The [[http://slackbasics.org/html/netconfig.html|networking chapter]] is well worth reading. |
| |
| In essence, my Wiki article documents the ''/etc/rc.d/rc.inet1.conf'' file. The only available documentation about the configurable network parameters used to be at the bottom of that file, and it took the shape of commented-out examples. In Slackware 12.2 two man pages were added, for [[http://slackware.osuosl.org/slackware-12.2/source/n/network-scripts/manpages/rc.inet1.8|rc.inet1]] and [[http://slackware.osuosl.org/slackware-12.2/source/n/network-scripts/manpages/rc.inet1.conf.5|rc.inet1.conf]], both of which are based on this Wiki article. \\ The ''rc.inet1'' script in Slackware configures all your network interfaces - including wireless interfaces. If the ''rc.inet1'' script detects that it deals with a //wireless interface//, it will call the sub-script ''rc.wireless'' to configure this interface's wireless properties. Both scripts take their configuration information from the same file ''rc.inet1.conf''. \\ I wrote a separate chapter about [[#wireless_networks|Wireless Networks]] because a wireless network interface has so many more configurable parameters than a "wired" interface. The configuration of [[#wpa_encryption|WPA encryption]] a for wireless interface is documented in it's own chapter; the WPA parameters are taken from the file ''/etc/wpa_supplicant.conf'' instead of the ''rc.inet1.conf'' file. \\ The final section of this article looks at alternative (mainly GUI based) network configuration managers and the extent to which these may be useful in Slackware. | In essence, my Wiki article documents the ''/etc/rc.d/rc.inet1.conf'' file. The only available documentation about the configurable network parameters used to be at the bottom of that file, and it took the shape of commented-out examples. In Slackware 12.2 two man pages were added, for [[http://slackware.osuosl.org/slackware-12.2/source/n/network-scripts/manpages/rc.inet1.8|rc.inet1]] and [[http://slackware.osuosl.org/slackware-12.2/source/n/network-scripts/manpages/rc.inet1.conf.5|rc.inet1.conf]], both of which are based on this Wiki article. \\ The ''rc.inet1'' script in Slackware configures all your network interfaces - including wireless interfaces. If the ''rc.inet1'' script detects that it deals with a //wireless interface//, it will call the sub-script ''rc.wireless'' to configure this interface's wireless properties. Both scripts take their configuration information from the same file ''rc.inet1.conf''. \\ I wrote a separate chapter about [[#wireless_networks|Wireless Networks]] because a wireless network interface has so many more configurable parameters than a "wired" interface. The configuration of [[#wpa_encryption|WPA encryption]] a for wireless interface is documented in it's own chapter; the WPA parameters are taken from the file ''/etc/wpa_supplicant.conf'' instead of the ''rc.inet1.conf'' file. \\ The final section of this article looks at alternative network configuration managers (who usually come with a GUI based client program) that have become available for Slackware over time. |
| |
| I will also try to give some historic perspective on the evolution of network support in Slackware, because I was involved in this a lot. | I will also try to give some historic perspective on the evolution of network support in Slackware, because I was involved in this a lot. |
