Welcome to the new location of Alien's Wiki, sharing a single dokuwiki install with the SlackDocs Wiki.
Welcome to Eric Hameleers (Alien BOB)'s Wiki pages.
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision |
slackware:ndiswrapper [2008/09/11 11:29] – WPA has it's own independent chapter now. alien | slackware:ndiswrapper [2008/09/11 11:33] – Be more specific about how to configure wpa with ndiswrapper. alien |
---|
| |
Your card will be loaded with the name **wlan0**. Detailed information about how to configure your wlan0 interface can be found in my [[:slackware:madwifi#network_configuration|madwifi page]], if you change the string **ath0** to **wlan0**. | Your card will be loaded with the name **wlan0**. Detailed information about how to configure your wlan0 interface can be found in my [[:slackware:madwifi#network_configuration|madwifi page]], if you change the string **ath0** to **wlan0**. |
| |
| |
| |
For more information about how to configure WPA using [[http://hostap.epitest.fi/wpa_supplicant/|wpa_supplicant]], read my [[:slackware:network#wpa_encryption|WPA chapter]] in the //[[:slackware:network|Slackware network configuration]]// page. | For more information about how to configure WPA using [[http://hostap.epitest.fi/wpa_supplicant/|wpa_supplicant]], read my [[:slackware:network#wpa_encryption|WPA chapter]] in the //[[:slackware:network|Slackware network configuration]]// page. |
| |
//NOTE//: With ndiswrapper version 1.12 and later, you should use wpa_supplicant's //wext// driver instead of the //ndiswrapper// driver: '''-Dwext''' instead of '''-Dndiswrapper'''. | <note>With ndiswrapper version 1.12 and later, you should use wpa_supplicant's **//wext//** driver instead of the //ndiswrapper// driver: the argument to wpa_supplicant would become '''-Dwext''' instead of '''-Dndiswrapper'''\\ A typical configuration line in ''rc.inet1.conf'' would then become (adjust my example index [**1**] to the value you use for your card): <code> |
| WLAN_WPADRIVER[1]="wext"</code></note> |