Welcome to the new location of Alien's Wiki, sharing a single dokuwiki install with the SlackDocs Wiki.
Welcome to Eric Hameleers (Alien BOB)'s Wiki pages.
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision |
slackware:ndiswrapper [2006/05/29 06:42] – Add nuance about large kernel stack size requirement. alien | slackware:ndiswrapper [2008/09/11 11:33] – Be more specific about how to configure wpa with ndiswrapper. alien |
---|
| |
Your card will be loaded with the name **wlan0**. Detailed information about how to configure your wlan0 interface can be found in my [[:slackware:madwifi#network_configuration|madwifi page]], if you change the string **ath0** to **wlan0**. | Your card will be loaded with the name **wlan0**. Detailed information about how to configure your wlan0 interface can be found in my [[:slackware:madwifi#network_configuration|madwifi page]], if you change the string **ath0** to **wlan0**. |
| |
| |
| |
| |
===== WPA encryption for your wireless network ===== | ===== WPA encryption for your wireless network ===== |
| |
For more information about how to configure WPA using [[http://hostap.epitest.fi/wpa_supplicant/|wpa_supplicant]], read my [[:slackware:madwifi#support_for_wpa_encryption|WPA chapter]] in the madwifi page. | For more information about how to configure WPA using [[http://hostap.epitest.fi/wpa_supplicant/|wpa_supplicant]], read my [[:slackware:network#wpa_encryption|WPA chapter]] in the //[[:slackware:network|Slackware network configuration]]// page. |
| |
//NOTE//: With ndiswrapper version 1.12 and later, you should use wpa_supplicant's //wext// driver instead of the //ndiswrapper// driver: '''-Dwext''' instead of '''-Dndiswrapper'''. | <note>With ndiswrapper version 1.12 and later, you should use wpa_supplicant's **//wext//** driver instead of the //ndiswrapper// driver: the argument to wpa_supplicant would become '''-Dwext''' instead of '''-Dndiswrapper'''\\ A typical configuration line in ''rc.inet1.conf'' would then become (adjust my example index [**1**] to the value you use for your card): <code> |
| WLAN_WPADRIVER[1]="wext"</code></note> |