Welcome to the new location of Alien's Wiki, sharing a single dokuwiki install with the SlackDocs Wiki.
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| wiki:talk:slackware:madwifi [2007/12/30 22:57] – 70.17.171.144 | wiki:talk:slackware:madwifi [2008/09/11 00:58] (current) – 71.49.35.95 | ||
|---|---|---|---|
| Line 5: | Line 5: | ||
| -------------------------------------------- | -------------------------------------------- | ||
| - | 600 might not be the best permission for wpa_supplicant.conf. | + | // |
| + | | ||
| + | The psk is not read on my system when i chmod 600 this file. | ||
| + | |||
| + | Hi! Pity you don't give any other info. With a mode 600 for the configuration file, wpa_supplicant works perfectly on a lot of other computers. You should check what you are doing out of the ordinary. Do you try to run wpa_supplicant as non-root? The permission is set to prevent non-root users from ' | ||
| + | --- Eric | ||
| + | |||
| + | |||
| + | as far as i can tell, i'm not doing anything out of the ordinary. | ||
| + | |||
| + | // | ||
| + | Using the trunk madwifi drivers with 2.6.26 kernel and wpa_supplicant 0.6.4, I have to use ' | ||
| + | |||
| + | wpakey -i ath0 -w | ||
| + | |||
| + | This enables wpa and allows wpa_supplicant to authenticate with my access point. | ||
| + | |||
| + | Shane | ||